NO.10 SOUND JUMPS [ENTIRE AUDIO SYSTEM]
id0903e2946500
10 |
Sound jumps |
||
---|---|---|---|
Possible DTC |
Using the M-MDS |
B1188:64 |
|
Without using M-MDS (On-board diagnostic test mode) |
10:Er07 |
||
Possible cause
|
• Electronic jamming from outside, or inferior condition of broadcasting station radio wave
• Defective CD (e.g., cracked, badly bent, rough edges, scratch, dirty CD, condensation)
• Vibration while vehicle is driven
• Speaker muted by Bluetooth system (hands-free telephone (HF/TEL) system) operation (with Bluetooth system)
• Open or short circuit in wiring harness between audio amplifier and audio unit
• Short circuit inside speaker
• Speaker malfunction
• Mis-operation of steering switches
• Audio unit malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
• Does the sound jump only while in the radio mode?
|
Yes
|
Go to Step 2.
|
No
|
Go to Step 5.
|
||
2
|
• Does noise occur?
|
Yes
|
Go to the next step.
|
No
|
Replace the audio unit.
|
||
3
|
• Can the location where the sound jumps be specified?
|
Yes
|
The system is normal. Explain to the customer that the noise is caused by radio wave disturbances or broadcast wave conditions from the outside.
|
No
|
Go to the next step.
|
||
4
|
• Can the broadcast where the sound jumps be specified?
|
Yes
|
Explain to the customer that the cause is poor broadcast reception conditions.
|
No
|
Replace the audio unit.
|
||
5
|
• Does the sound jump only while in the CD mode?
|
Yes
|
Go to the next step.
|
No
|
Go to Step 8.
|
||
6
|
• Can the disc in which the sound jump occurs be specified?
|
Yes
|
The system is normal. Explain to the customer that the cause is a disc that is damaged or dirty on the playback side, or warped.
|
No
|
Go to the next step.
|
||
7
|
• Drive the vehicle and verify the malfunction symptom.
• Does noise occur while driving on an unlevel road or under other driving conditions (sudden curve, quick operation)?
|
Yes
|
The system is normal. Explain to the customer that the cause is vibration while the vehicle is driven.
|
No
|
Replace the audio unit.
|
||
8
|
• Does the sound jump using the specified speaker?
|
Yes
|
Without Bose®
• Go to the next step.
With Bose®
• Go to Step 10
|
No
|
With Bluetooth system
• Go to Step 13.
Without Bluetooth system
• Go to Step 14.
|
||
9
|
• Disconnect the speaker connector and inspect the resistance of speaker.
• Inspect the continuity between the audio unit wiring harness-side connector terminal and speaker wiring harness-side connector:
Audio unit—front door speaker
Audio unit—rear door speaker
|
Yes
|
Go to Step 12.
|
No
|
Repair or replace the suspect wiring harness or speaker.
|
||
10
|
• Disconnect the audio amplifier connector.
• Inspect continuity between the following terminals of the audio amplifier connector and speaker connector.
For front door speaker
― Terminal 3L (LH+)—Terminal B
― Terminal 3N (LH-)—Terminal A
― Terminal 3K (RH+)—Terminal B
― Terminal 3M (RH-)—Terminal A
For front speaker
― Terminal 3B (LH+)—Terminal B
― Terminal 3A (LH-)—Terminal A
― Terminal 3D (RH+)—Terminal B
― Terminal 3F (RH-)—Terminal A
For rear door speaker
― Terminal 3I (LH+)—Terminal B
― Terminal 3G (LH-)—Terminal A
― Terminal 3C (RH+)—Terminal B
― Terminal 3E (RH-)—Terminal A
For rear speaker
― Terminal 4G—Terminal B
― Terminal 4E—Terminal A
― Terminal 4D—Terminal B
― Terminal 4C—Terminal A
For center speaker
― Terminal 3H—Terminal B
― Terminal 3J—Terminal A
• Is there continuity?
|
Yes
|
Go to Step 11.
|
No
|
Repair or replace the repair related wiring harnesses.
|
||
11
|
• Disconnect the audio amplifier connector.
• Inspect the continuity between the audio amplifier connector and ground:
For front door speaker
― Terminal 3L (LH+)—Terminal B
― Terminal 3N (LH-)—Terminal A
― Terminal 3K (RH+)—Terminal B
― Terminal 3M (RH-)—Terminal A
For front speaker
― Terminal 3B (LH+)—Terminal B
― Terminal 3A (LH-)—Terminal A
― Terminal 3D (RH+)—Terminal B
― Terminal 3F (RH-)—Terminal A
For rear door speaker
― Terminal 3I (LH+)—Terminal B
― Terminal 3G (LH-)—Terminal A
― Terminal 3C (RH+)—Terminal B
― Terminal 3E (RH-)—Terminal A
For rear speaker
― Terminal 4G—Terminal B
― Terminal 4E—Terminal A
― Terminal 4D—Terminal B
― Terminal 4C—Terminal A
For center speaker
― Terminal 3H—Terminal B
― Terminal 3J—Terminal A
• Is there continuity?
|
Yes
|
Repair or replace the related wiring harness or speaker.
|
No
|
Go to the next step.
|
||
12
|
• Inspect the suspect speaker.
• Is the speaker normal?
|
Yes
|
With Bluetooth system
• Go to the next step.
Without Bluetooth system
• Go to Step 14.
|
No
|
Without Bose®
• Replace the speaker.
(See TWEETER REMOVAL/INSTALLATION.) (Six-speaker type )
With Bose®
• Replace the speaker.
|
||
13
|
• Does the malfunction occur while the Bluetooth system is operating?
|
Yes
|
The system is normal. Explain to the customer that the speaker is muted while the Bluetooth system is operating.
|
No
|
Go to the next step.
|
||
14
|
• Do the steering switches operate?
|
Yes
|
The system is normal. Explain to the customer that the cause is mis-operation of the steering switches.
|
No
|
Replace the audio unit.
|