CONDENSER REMOVAL/INSTALLATION
id092000803000
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Trunk box (See TRUNK BOX REMOVAL/INSTALLATION.)
- (2) Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION.)
- (3) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
- (4) Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION.)
- (5) Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION.)
- (6) Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
- (7) Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
- (8) Roof side trim (See ROOF SIDE TRIM REMOVAL/INSTALLATION.)
- (9) Third-row seat belt upper anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION.)
- (10) D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Slightly bend back the headliner.
4. Remove in the order indicated in the table.
|
1
|
Bolt
|
|
2
|
Connector
|
|
3
|
Condenser
|
5. Install in the reverse order of removal.
