DTC U0415:00 [SELECTOR LEVER]

id0502z3300900


Outline

System malfunction location

CAN communication: Error signal received from electronically controlled brake unit
Detection condition
•  Selector lever receives signal error from electronically controlled brake unit (CAN bus No.1 or CAN bus No.2).
Fail-safe
Refer to the DTC table and fail-safe table according to the DTC. (See DTC TABLE [SELECTOR LEVER].)
Vehicle status when DTCs are output
Not applicable
Possible cause
•  DTCs are stored in the electronically controlled brake unit.
•  Electronically controlled brake unit malfunction
System wiring diagram
Not applicable
Connector diagram
Not applicable


Diagnostic Procedure

Step

Inspection

Results

Action
1
INSPECT ELECTRONICALLY CONTROLLED BRAKE UNIT FOR MALFUNCTION
•  Perform the DTC inspection for the electronically controlled brake unit.
•  Is a DTC displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT].)
No
Go to the next step.
Repair completion verification 1
VERIFY IF VEHICLE IS REPAIRED
•  Install/connect the part removed/disconnected during the troubleshooting procedure.
•  Clear the DTC recorded in the memory.
•  Perform the DTC inspection for the selector lever.
•  Is the same Pending DTC present?
Yes
Refer to the CAN (controller area network) malfunction diagnosis flow to inspect for a CAN communication error.
(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [L.H.D. (E)].)
(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [R.H.D.].)
If the CAN communication is normal, perform the diagnosis from Step 1 again.
•  If the malfunction is not resolved, replace the selector lever, then go to the next step.
No
Go to the next step.
Repair completion verification 2
VERIFY IF OTHER DTCs ARE DISPLAYED
•  Perform the DTC inspection.
•  Is a DTC displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.