AUTO LIGHT SENSOR INSPECTION

id091800704800

Note

•  The integrity of the auto light sensor cannot be determined from a single part. When inspecting the auto light sensor, perform the following procedure.

1.  Connect the M-MDS to the DLC-2.

2.  Perform the DTC inspection for the body control module (BCM) and verify if any DTCs related to the auto light sensor is detected. (See DTC INSPECTION.)

•  If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting.(See DTC TABLE [BODY CONTROL MODULE (BCM) (E)].)