DTC P0AC6:00 [BECM (e-SKYACTIV)]

id300201001900

Warning

<<High voltage>>

•  If the necessary measures are not taken before servicing an electric vehicle, it could cause electrical shock and result in serious injury or, in the worst case, death. Before servicing the electric vehicle, refer to [HIGH VOLTAGE SERVICE CAUTIONS] in the general information and implement the necessary measures. (See HIGH VOLTAGE SERVICE CAUTIONS.)

Outline

System malfunction location	High voltage battery temperature sensor No.2 system: Deviation error
Detection condition	•  The BECM detects that the difference between the measured temperature at high voltage battery temperature sensor No.2 and the median value of the measured temperatures at high voltage battery temperature sensors No.2, No.5, No.8, and No.15 exceeds 19 °C {34 °F} for 0.45 s.
Fail-safe	•  Refer to "DTC Table" and "Fail-safe Function Malfunction Contents Table". (See DTC TABLE [BECM (e-SKYACTIV)].)
Possible cause	High voltage battery malfunction •  Internal parts malfunction
System wiring diagram	•  Not applicable
Connector diagram	•  Not applicable

Diagnostic Procedure

Warning

<<High voltage>>

•  If necessary measures such as wearing the correct protective gear are not taken when inspecting or removing/installing the high voltage parts, it could cause electrical shock and result in serious injury or, in the worst case, death.

•  Before inspecting or removing/installing the high voltage parts, refer to [HIGH VOLTAGE SERVICE CAUTIONS] in the general information and [High Voltage Part Inspection and Removal/Installation Notes] of the high voltage system service cautions and implement the necessary measures and preparations. (See HIGH VOLTAGE SERVICE CAUTIONS.) (See HIGH VOLTAGE SYSTEM SERVICE CAUTIONS.)

Step	Inspection	Results	Action
1	RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION •  Record the snapshot data. Note •  Recording can be facilitated using the screen capture function of the PC.	—	Go to the next step.
2	PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS HIGH VOLTAGE BATTERY •  Clear the DTC recorded in the memory. (See CLEARING DTC.) •  Perform the DTC inspection for the BECM. (See DTC INSPECTION.) •  Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [L.H.D. (E)].) (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [R.H.D.].) If the CAN communication is normal, replace the high voltage battery and perform the repair completion verification. (See HIGH VOLTAGE BATTERY REMOVAL/INSTALLATION.)
		No	Go to the next step.
Repair completion verification	VERIFY IF OTHER DTCs DISPLAYED •  Perform the DTC inspection. (See DTC INSPECTION.) •  Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
		No	DTC troubleshooting completed.