DTC C100B:19 [PARKING LOCK ACTUATOR]

id0502z4585400

Outline

System malfunction location

Parking lock actuator system (internal malfunction)

Detection condition

• The actuator current value of the parking lock actuator exceeds the specified value.

Fail-safe

Refer to the DTC table and fail-safe table according to the DTC. (See DTC TABLE [PARKING LOCK ACTUATOR].)

Possible cause

• Parking lock actuator internal malfunction

System wiring diagram

Not applicable

Connector diagram

Not applicable

System malfunction location	Parking lock actuator system (internal malfunction)
Detection condition	• The actuator current value of the parking lock actuator exceeds the specified value.
Fail-safe	Refer to the DTC table and fail-safe table according to the DTC. (See DTC TABLE [PARKING LOCK ACTUATOR].)
Possible cause	• Parking lock actuator internal malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable

Diagnostic Procedure

Step

Inspection

Results

Action

1

INSPECT PARKING LOCK ACTUATOR FOR MALFUNCTION DEPENDING ON REPEATABILITY

•  Clear the DTC recorded in the memory.
(See CLEARING DTC.)

•  Perform the DTC inspection for the parking lock actuator.
(See DTC INSPECTION.)

•  Is the same Pending DTC present?

Yes

Refer to the CAN (controller area network) malfunction diagnosis flow to inspect for a CAN communication error.

(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW.)

If the CAN communication is normal, perform the diagnosis from Step 1 again.

•  If the malfunction is not resolved, replace the parking lock actuator, then go to the next step.
(See PARKING LOCK ACTUATOR REMOVAL/INSTALLATION [ET6A-EL, ET6AX-EL].)

No

Go to the next step.

Repair completion verification

VERIFY IF OTHER DTCs ARE DISPLAYED

•  Perform the DTC inspection.
(See DTC INSPECTION.)

•  Is a DTC displayed?

Yes

Repair the malfunctioning part according to the applicable DTC troubleshooting.

No

DTC troubleshooting completed.

Step	Inspection	Results	Action
1	INSPECT PARKING LOCK ACTUATOR FOR MALFUNCTION DEPENDING ON REPEATABILITY • Clear the DTC recorded in the memory. (See CLEARING DTC.) • Perform the DTC inspection for the parking lock actuator. (See DTC INSPECTION.) • Is the same Pending DTC present?	Yes	Refer to the CAN (controller area network) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW.) If the CAN communication is normal, perform the diagnosis from Step 1 again. • If the malfunction is not resolved, replace the parking lock actuator, then go to the next step. (See PARKING LOCK ACTUATOR REMOVAL/INSTALLATION [ET6A-EL, ET6AX-EL].)
1		No	Go to the next step.
Repair completion verification	VERIFY IF OTHER DTCs ARE DISPLAYED • Perform the DTC inspection. (See DTC INSPECTION.) • Is a DTC displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting.
Repair completion verification		No	DTC troubleshooting completed.