FRONT CROSS TRAFFIC ALERT (FCTA) WARNING SOUND DOES NOT ACTIVATE [FRONT CROSS TRAFFIC ALERT (FCTA)]

id1503d1027900

Outline

Description

•  The front cross traffic alert (FCTA) warning sound is not activated even though the front cross traffic alert (FCTA) warning indication is flashing.

Possible cause

•  Personalization feature not set

•  Connectivity master unit (CMU) malfunction

•  Front side radar sensor malfunction

Diagnostic Procedure

Step

Inspection

Results

Action

1

VERIFY ALL SYSTEM DTCs

•  Perform the DTC inspection.
(See DTC INSPECTION.)

•  Are any DTCs displayed?

Yes

Repair the malfunctioning location according to the applicable DTC troubleshooting.

No

Go to the next step.

2

VERIFY PERSONALIZATION FEATURES SETTING

•  Verify the [Front Cross Traffic Alert] using the personalization features.
(Refer to the [PERSONALIZATION FEATURES] in the workshop manual)

•  Has the [Front Cross Traffic Alert] turned [Disable]?

Yes

Complete the symptom troubleshooting. (Explain the system operation conditions to the customer.)

No

Go to the next step.

Repair completion verification

VERIFY THAT VEHICLE IS REPAIRED

•  Install/connect the part removed/disconnected during the troubleshooting procedure.

•  Has the malfunction symptom been eliminated?

Yes

Complete the symptom troubleshooting. (Explain contents of repair to customer)

No

Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.

(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW.)

If the CAN communication is normal, perform the diagnosis from Step 1.

•  If the malfunction is not resolved, replace the front side radar sensor.
(See REAR SIDE RADAR SENSOR REMOVAL/INSTALLATION.)

Description	• The front cross traffic alert (FCTA) warning sound is not activated even though the front cross traffic alert (FCTA) warning indication is flashing.
Possible cause	• Personalization feature not set • Connectivity master unit (CMU) malfunction • Front side radar sensor malfunction

Step	Inspection	Results	Action
1	VERIFY ALL SYSTEM DTCs • Perform the DTC inspection. (See DTC INSPECTION.) • Are any DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
1		No	Go to the next step.
2	VERIFY PERSONALIZATION FEATURES SETTING • Verify the [Front Cross Traffic Alert] using the personalization features. (Refer to the [PERSONALIZATION FEATURES] in the workshop manual) • Has the [Front Cross Traffic Alert] turned [Disable]?	Yes	Complete the symptom troubleshooting. (Explain the system operation conditions to the customer.)
2		No	Go to the next step.
Repair completion verification	VERIFY THAT VEHICLE IS REPAIRED • Install/connect the part removed/disconnected during the troubleshooting procedure. • Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. (Explain contents of repair to customer)
Repair completion verification		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW.) If the CAN communication is normal, perform the diagnosis from Step 1. • If the malfunction is not resolved, replace the front side radar sensor. (See REAR SIDE RADAR SENSOR REMOVAL/INSTALLATION.)