Diagnostic procedure
|
STEP
|
INSPECTION
|
ACTION
|
|
|---|---|---|---|
|
1
|
VERIFY THAT THE CORRECT DSC HU/CM IS INSTALLED
• Verify the part number of the DSC HU/CM.
• Is the part number correct?
|
Yes
|
Go to the next step.
|
|
No
|
After replacing the DSC HU/CM, go to Step 3.
|
||
|
2
|
PERFORM CONFIGURATION
• Was configuration performed normally?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the DSC HU/CM, then go to the next step.
|
||
|
3
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory.
(See Clearing DTCs Procedures.)
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Are any other DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC Table.)
|
|
No
|
DTC troubleshooting completed.
|
||