NO.11 DSC*2 OPERATES FREQUENTLY/DSC DOES NOT WORK CORRECTLY*2: DSC INDICATOR LIGHT GOES ON AND OFF WHILE DSC IS OPERATING


11	*DSC (2) operates frequently. /DSC does not work correctly. (2): DSC indicator light goes on and off while DSC is operating.*
[TROUBLESHOOTING HINTS] • DSC HU/CM detected malfunction (input and output device malfunction) • Poor installation of yaw rate sensor, lateral-G sensor and/or steering angle sensor (If any of the above sensors are poorly installed, DSC may operate intermittently) • When replacing the DSC HU/CM, combined sensor or steering angle sensor, initialization is not performed. (If initialization is not performed correctly, DSC may not work correctly)


STEP	INSPECTION		ACTION
1	INSPECT DSC HU/CM FOR DTCs • Inspect the DTC for the DSC ON-BOARD DIAGNOSTIC SYSTEM. • Have DTCs been recorded in memory?	Yes	Perform the applicable DTC inspection. (See DTC Table.)
1		No	Go to the next step.
2	VERIFY THAT EACH SENSOR IS INSTALLED • Are the combined sensor and steering angle sensor securely installed?	Yes	Go to the next step.
2		No	Install sensor securely.
*3	VERIFY THAT EACH SENSOR IS INITIALIZED • Was initialization performed after replacement of the DSC HU/CM, combined sensor or steering angle sensor?	Yes	Find malfunctioning part according to "INTERMITTENT CONCERN TROUBLESHOOTING."
*3		No	Perform initialization procedure. (See COMBINED SENSOR INITIALIZATION PROCEDURE.) (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE.)