NO.1 CD PLAYER/CHANGER DOES NOT LOAD THE CD OR EJECTS THE CD IMMEDIATELY

id0903a2826100

1

CD player/changer does not load the CD or ejects the CD immediately

Possible DTC: 03:Er01, 03:Er10, 06:Er01, 06:Er10, 10:Er01, 10:Er10, 22:Er01, 22:Er10

Troubleshooting hints
• CD is inserted upside down
• Audio unit is malfunctioning
• Defective CD (e.g., cracked, badly bent, rough edges, scratch, dirty CD, condensation)
• Non-conventional discs (e.g., 8 cm (3 in) CD, 8 cm (3 in) disc adapter, heart-shaped disc, octagonal disc)
• Poor connection of audio unit connector or terminal (e.g., damaged, bent, pulled-out pin, corrosion)
• Deformed disc is used (e.g., out of specification (thickness), bent disc)

Diagnostic procedure

STEP

INSPECTION

ACTION

1
• Is CD inserted properly, label-side up?
Yes
Go to the next step.
No
Explain to the customer that the CD should be inserted into the slot label-side up.
2
• Replace with a CD known to be operational.
• Does the CD player/changer load the CD?
Yes
Go to the next step.
No
Replace the audio unit.
3
Visually inspect the CD.
- Is there any dirt, scratches or deformation on the CD?
- Is the CD a non-conventional disc?
Yes
Explain to the customer that the defective CD or non-conventional disc cannot be used.
No
Go to the next step.
4
• Turn the ignition switch to the LOCK position.
• Inspect the connection of the audio unit connector (24-pin).
• Inspect both the audio unit connector and wiring harness-side connector for a poor connection. (such as damaged/bent/pulled-out pins, corrosion)
• All the pins and connector normal?
Yes
Replace the audio unit.
No
If the audio unit connector/pin is malfunctioning:
• Replace the audio unit.
If the wiring harness-side connector/pin is malfunctioning:
• Repair or replace the pins and/or the connector.