 |
amxzzw00001433
REAR OIL SEAL REPLACEMENT [L8, LF]
id0110a9800900
1. Remove the flywheel (MT) or remove the drive plate (AT). (See CLUTCH UNIT REMOVAL/INSTALLATION.) (See DRIVE PLATE REMOVAL/INSTALLATION [SJ6A-EL].)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
amxzzw00001433
|
|
1
|
Bolt
|
|
2
|
Rear oil seal
|
Rear Oil Seal Installation Note
1. Apply silicone sealant to the mating faces as shown.
amxzzw00002112
|
2. Apply clean engine oil to the new oil seal lip.
3. Install the SST to the non-woven fabric side of the rear oil seal.
amxzzw00001434
|
4. From the back side of the rear oil seal, verify that there is no damage or separation in the lip area of the rear oil seal.
amxzzw00001435
|
5. Install the rear oil seal to the engine as shown in the figure.
amxzzw00001436
|
6. Tighten the rear oil seal bolts in the order as shown.
amxzzw00001437
|
