MASS AIR FLOW (MAF) SENSOR INSPECTION [L8, LF]

id0140i7800700

Visual inspection

1.  Visually inspect the MAF sensor for the following:

•  Damage, cracks, soiling

•  Rusted sensor terminal

•  Bent sensor terminal

―  If there is any malfunction, repair or replace the MAF/IAT sensor. (See MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REMOVAL/INSTALLATION [L8, LF].)

Voltage Inspection

1.  Remove the MAF/IAT sensor without disconnecting the MAF/IAT sensor connector.

2.  Connect the M-MDS to the DLC-2.

amxzzw00000037

3.  Turn the ignition switch to the ON position.

4.  As the air gradually approaches the MAF detection part of the MAF/IAT sensor, verify that the MAF sensor output voltage (M-MDS PID: MAF) varies.

•  If not as verified, replace the MAF/IAT sensor. (See MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REMOVAL/INSTALLATION [L8, LF].)