UP SWITCH INSPECTION [SJ6A-EL]

id051311500500


Continuity Inspection

Note
•  The up position switch is built into the selector lever component.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Selector lever knob (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)
(2)  Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION.)

3.  Disconnect the selector lever component connector.

amxuuw00002843

4.  Verify that the continuity between selector lever component terminals C and H.

adejjw00010856

•  If not as verified, replace the selector lever component. (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)

Up switch specification

Test condition

Continuity
Selector lever is in the M position (+) side position.
Continuity
Selector lever is not in the M position (+) side position.
No continuity