OIL SEAL (EXTENSION HOUSING) REPLACEMENT [SJ6A-EL]

id051311710000

1.  Clean the transmission exterior thoroughly with a steam cleaner or cleaning solvent.

2.  Remove the tunnel member.

amxuuw00003817

3.  Disconnect the HO2S harness bracket from the TWC. (See HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

4.  Disconnect the TWC from the exhaust manifold (WU-TWC). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

5.  Suspend the TWC using a cable as shown in the figure.

amxuuw00002847

6.  Remove the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION.)

7.  Using a plastic hammer and slab of wood, tap the extension dust deflector to remove it.

amxuuw00003542

Caution

•  Do not to damage the extension dust deflector.

•  Do not to damage the extension housing.

8.  Using a tape-wrapped flathead screwdriver, remove the extension housing shroud.

amxuuw00003543

9.  Using a tape-wrapped flathead screwdriver, remove the oil seal (extension housing).

amxuuw00003544

10.  Using the SST and a hammer, install the new oil seal to the extension housing.

amxuuw00005630

11.  Coat the oil seal lip with grease.

12.  Using the SST and a hammer, install the new extension housing shroud to the extension housing.

amxuuw00005631

13.  Using a plastic hammer and slab of wood, install the extension dust deflector to the extension housing.

amxuuw00003547

14.  Install the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION.)

15.  Connect the TWC to the exhaust manifold (WU-TWC). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

16.  Connect the HO2S harness bracket to theTWC. (See HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

17.  Install the tunnel member.

amxuuw00003818

18.  Adjust the ATF level. (See AUTOMATIC TRANSMISSION FLUID (ATF) LEVEL ADJUSTMENT [SJ6A-EL].)