DTC U0401:00 [EPS CONTROL MODULE]

id060230812200

DTC

U0401:00

Signal error from PCM

DETECTION CONDITION

•  Error detected in signal from PCM via CAN communication.

FAIL-SAFE FUNCTION

•  Refer to “Fail-safe function table”. (See DTC TABLE [EPS CONTROL MODULE].)

POSSIBLE CAUSE

•  PCM malfunction

SYSTEM WIRING DIAGRAM

—

Diagnostic Procedure

Step

Inspection

Action

1

VERIFY PCM DTC

•  Using the M-MDS, perform the PCM DTC inspection.
(See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].)

•  Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].)

DTC troubleshooting completed, then go to the next step.

No

Go to the next step.

2

VERIFY DTC TROUBLESHOOTING COMPLETED

•  Using the M-MDS, clear the DTC from the EPS control module.
(See CLEARING DTC [EPS CONTROL MODULE].)

•  Using the M-MDS, perform the EPS control module DTC inspection.
(See DTC INSPECTION [EPS CONTROL MODULE].)

•  Is the same Pending DTC present?

Yes

Repeat the inspection from Step1.

If the malfunction recurs, replace the PCM, then go to the next step.

(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

No

Go to the next step.

3

VERIFY NO DTC IS PRESENT

•  Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [EPS CONTROL MODULE].)

No

DTC troubleshooting completed.

DTC	U0401:00	Signal error from PCM
DETECTION CONDITION		• Error detected in signal from PCM via CAN communication.
FAIL-SAFE FUNCTION		• Refer to “Fail-safe function table”. (See DTC TABLE [EPS CONTROL MODULE].)
POSSIBLE CAUSE		• PCM malfunction
SYSTEM WIRING DIAGRAM		—

Step	Inspection		Action
1	VERIFY PCM DTC • Using the M-MDS, perform the PCM DTC inspection. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].) DTC troubleshooting completed, then go to the next step.
1		No	Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED • Using the M-MDS, clear the DTC from the EPS control module. (See CLEARING DTC [EPS CONTROL MODULE].) • Using the M-MDS, perform the EPS control module DTC inspection. (See DTC INSPECTION [EPS CONTROL MODULE].) • Is the same Pending DTC present?	Yes	Repeat the inspection from Step1. If the malfunction recurs, replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [EPS CONTROL MODULE].)
3	VERIFY NO DTC IS PRESENT • Are any DTCs present?	No	DTC troubleshooting completed.