FUEL-FILLER LID LOCK ACTUATOR INSPECTION


id091400009600

1.  Open the fuel-filler lid.

2.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

3.  Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION.)

4.  Partially peel back the trunk side trim (LH) to the position allowing removal of the fuel-filler lid lock actuator. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

5.  Disconnect the fuel-filler lid lock actuator connector. (See FUEL-FILLER LID LOCK ACTUATOR REMOVAL/INSTALLATION.)

6.  Apply battery positive voltage and connect the ground to the fuel-filler lid lock actuator terminals as indicated in the table below and verify the operation condition.

ardjjw00005033

B+ terminal

Ground terminal

Operation

A
B
Lock
B
A
Unlock

•  If not as indicated in the table, replace the fuel-filler lid lock actuator. (See FUEL-FILLER LID LOCK ACTUATOR REMOVAL/INSTALLATION.)