VACUUM SENSOR 2 INSPECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0]

VACUUM SENSOR 2 INSPECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0]

id0140g8902100

Voltage Inspection

1. Connect the M-MDS to the DLC-2.

2. Switch the ignition ON (engine off).

3. Verify that the vacuum sensor 2 output voltage (PID: BBP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 1.5, SKYACTIV-G 2.0)].) (See PCM INSPECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0].)

• If not as specified, replace the power brake unit. (See POWER BRAKE UNIT REMOVAL/INSTALLATION [L.H.D.].) (See POWER BRAKE UNIT REMOVAL/INSTALLATION [R.H.D.].)

Specification (Reference)

amxzzw00003565