DTC B1001:55, B1003:55 [SAS CONTROL MODULE (ACTIVE BONNET)]

id0802h4006500

System malfunction location	•  B1001:55: Configuration setting error (active bonnet actuator (RH) structural malfunction) •  B1003:55: Configuration setting error (active bonnet actuator (LH) structural malfunction)
Detection condition	Warning •  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure. •  SAS control module configuration setting has not been done correctly •  Parts which have not been set to SAS control module are assembled
Fail-safe function	Not applicable
Possible cause	•  SAS control module configuration setting not implemented •  SAS control module configuration setting invalid •  Active bonnet actuator (RH) or (LH) assembly incorrect •  SAS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE CONFIGURATION (AS-BUILT DATA USE) •  Perform the SAS control module configuration using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION (USING AS-BUILT DATA).) •  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (ACTIVE BONNET)].) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (ACTIVE BONNET)].) •  Are the same DTCs present?	Yes	Go to the next step.
		No	DTC troubleshooting completed.
2	INSPECT ACTIVE BONNET ACTUATOR (RH) OR (LH) INSTALLATION CONDITION •  Verify that the Active bonnet actuator (RH) or (LH) is correctly installed. •  Is the Active bonnet actuator (RH) or (LH) correctly installed?	Yes	Go to the next step.
		No	Correctly Install the Active bonnet actuator (RH) or (LH). (See ACTIVE BONNET ACTUATOR REMOVAL/INSTALLATION.) Then go to the next step.
3	PERFORM SAS CONTROL MODULE DTC INSPECTION •  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (ACTIVE BONNET)].) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (ACTIVE BONNET)].) •  Are the same DTCs present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
		No	DTC troubleshooting completed.