MAP LIGHT INSPECTION

id091800801300

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(2)  Female wedge (See FEMALE WEDGE REMOVAL/INSTALLATION.)

(3)  Front header trim (See FRONT HEADER TRIM REMOVAL/INSTALLATION.)

(4)  Map light (See MAP LIGHT REMOVAL/INSTALLATION.)

3.  Verify that the continuity between the map light terminals is as indicated in the table.

amxuuw00003310

amxuuw00003311

•  If not as indicated in the table, replace the map light bulb or the map light. (See MAP LIGHT BULB REMOVAL/INSTALLATION.) (See MAP LIGHT REMOVAL/INSTALLATION.)