VARIABLE TUMBLE SHUTTER VALVE ACTUATOR INSPECTION [L8, LF]

id0113a3803100

Operation Inspection

1.  Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [L8, LF].)

2.  Remove the following parts:

(1)  Front suspension tower bar (joint), (right side) and (left side) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION.)

(2)  Wiper arm and blade (See WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

(3)  Cowl grille (See COWL GRILLE REMOVAL/INSTALLATION.)

(4)  Side cowl grille (See SIDE COWL GRILLE REMOVAL/INSTALLATION.)

(5)  Move the cooler pipe No.3 and heater pipe slightly out of the way. (L.H.D.)

amxzzw00000834

(6)  Service hole cover (See EGR VALVE REMOVAL/INSTALLATION [L8, LF].)

amxzzw00000835

3.  Disconnect the vacuum hose from the variable tumble solenoid valve.

amxzzw00000805

4.  Connect a vacuum pump to the vacuum hose.

Note

•  Verify that the variable tumble shutter valve actuator rod moves using a mirror.

5.  Apply vacuum and verify that the rod moves.

•  If the rod dose not move, replace the variable tumble shutter valve actuator. (See VARIABLE TUMBLE SHUTTER VALVE ACTUATOR REMOVAL/INSTALLATION [L8, LF].)

•  When the variable tamble shatter valve actuator cannot be activated even though the operation of the rod can be confirmed, check for any incorrect connections or breakage of the vacuum hose.

Vacuum kPa {mmHg, inHg}	Rod movement
Below –2.7 {–20, –0.8}	No operate
Above –33.4 {–251, –9.86}	Fully pulled