INTRUDER SENSOR REMOVAL/INSTALLATION

id091400809400

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [L8, LF].)

2.  Remove the following parts:

(1)  Console (See CONSOLE REMOVAL/INSTALLATION.)

(2)  Quarter trim (See QUARTER TRIM REMOVAL/INSTALLATION.)

(3)  Scuff plate (SCUFF PLATE REMOVAL/INSTALLATION.)

(4)  Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(5)  Aeroboard (See AEROBOARD REMOVAL/INSTALLATION.)

(6)  Seat back bar garnish (See SEAT BACK BAR GARNISH REMOVAL/INSTALLATION.)

(7)  Back trim (See BACK TRIM REMOVAL/INSTALLATION.)

3.  Remove the nuts.

4.  Disconnect the connector, then remove the intruder sensor.

amxzzw00000585

5.  Install in the reverse order of removal.