CONDENSER REMOVAL/INSTALLATION
id092000803000
1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [L8, LF].)
3. Remove the following parts:
- (1) Console (See CONSOLE REMOVAL/INSTALLATION.)
- (2) Quarter trim (See QUARTER TRIM REMOVAL/INSTALLATION.)
- (3) Scuff plate (SCUFF PLATE REMOVAL/INSTALLATION.)
- (4) Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
- (5) Aeroboard (See AEROBOARD REMOVAL/INSTALLATION.)
- (6) Front seat back bar garnish (See SEAT BACK BAR GARNISH REMOVAL/INSTALLATION.)
- (7) Back trim (See BACK TRIM REMOVAL/INSTALLATION.)
- (8) Seat belt set plate (See SEAT BELT REMOVAL/INSTALLATION.)
- (9) Seat back crossmember assembly (See SEAT BACK CROSSMEMBER ASSEMBLY REMOVAL/INSTALLATION.)
- (10) Rear side trim (See REAR SIDE TRIM REMOVAL/INSTALLATION.)
- (11) Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
|
1
|
Connector
|
|
2
|
Bolt
|
|
3
|
Condenser
|
5. Install in the reverse order of removal.
