REAR OIL SEAL REPLACEMENT [MZ-CD 1.4 DI Turbo]


id0110b8800900

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

2.  Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

3.  Remove the front wheels and tires.

4.  Remove the fresh-air duct No.1. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

5.  Remove the air hose No.1. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZ-CD 1.4 DI Turbo].)

6.  Remove the manual transaxle. (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [B65M-R (MZ-CD 1.4 DI Turbo)].)

7.  Remove the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION [B65M-R].)

8.  Remove in the order indicated in the table.

9.  Install in the reverse order of removal.

b3e0110e218

1
Rear oil seal


Rear Oil Seal Removal Note

1.  Remove the rear oil seal using a flathead screwdriver with the tip protected by a rag to prevent crankshaft oil seal damage.


Rear Oil Seal Installation Note

1.  Apply clean engine oil to a new rear oil seal.

2.  Set the SSTs.

b3e0110e219

3.  Position the rear oil seal on the SST.

b3e0110e220

Note
•  A rear oil seal is supplied with an alignment sleeve which must be removed during the following installation.

4.  Install the rear oil seal using the SSTs.

b3e0110e221