INTAKE MANIFOLD VACUUM INSPECTION [SKYACTIV-G 1.3, SKYACTIV-G 1.5]

id0113q1801500

1.  Disconnect the evaporative hose (purge solenoid valve side) connecting the intake manifold and the purge solenoid valve, then install the vacuum gauge. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [SKYACTIV-G 1.3, SKYACTIV-G 1.5].)

2.  Verify that the intake air hoses are installed securely.

3.  Warm up the engine.

4.  Measure the intake manifold vacuum while idling (no load) using the vacuum gauge.

•  If not within the specification, perform the following inspections.
―  Compression pressure (See COMPRESSION INSPECTION [SKYACTIV-G 1.3, SKYACTIV-G 1.5].)
―  Check valve (See CHECK VALVE INSPECTION [SKYACTIV-G 1.3, SKYACTIV-G 1.5].)
―  Air suction
•  Installation areas of each vacuum hose
•  Evaporative hose connecting part
•  Installation area of throttle body
•  Installation area of fuel injector
•  Installation area of PCV valve
•  Installation area of intake manifold
Standard
Approx. –60.0 kPa {–450.0 mmHg, –17.7 inHg}