DTC P0610:00 [ZJ, ZY]
id0102c0706000
|
DTC P0610:00 |
PCM vehicle configuration error |
|---|---|
|
DETECTION CONDITION
|
• The PCM data configuration error.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Configuration has not been completed
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
PERFORM PCM CONFIGURATION
• Perform the “PCM CONFIGURATION”.
(See PCM CONFIGURATION [ZJ, ZY].)
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine.
• Perform the KOEO/KOER self test.
(See KOEO/KOER SELF TEST [ZJ, ZY].)
• Is the same DTC present?
|
Yes
|
Perform the “PCM CONFIGURATION” again, then go to the next step.
(See PCM CONFIGURATION [ZJ, ZY].)
|
|
No
|
Go to Step 5.
|
||
|
4
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine.
• Perform the KOEO/KOER self test.
(See KOEO/KOER SELF TEST [ZJ, ZY].)
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [ZJ, ZY].)
|
|
No
|
DTC troubleshooting completed.
|
||