SOLENOID VALVE REMOVAL/INSTALLATION

id051700804600

Warning
•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.

1.  Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

2.  Disconnect the negative battery cable.

3.  Drain the ATF into a separate suitable container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.)

4.  Remove the oil pan.

5.  Remove the control valve body. (See CONTROL VALVE BODY REMOVAL.).)

6.  Remove the solenoid valve(s).

am2zzw00000819

7.  Apply ATF to a new O‐ring and install it on the solenoid valve.

8.  Install the solenoid valve in the control valve body.

am2zzw00000820

Tightening torque
8—10 N·m
{82—101 kgf·cm, 71—88 in·lbf}

9.  Install the control valve body. (See CONTROL VALVE BODY INSTALLATION.)

10.  Install the oil pan.

11.  Add ATF. (See CONTROL VALVE BODY REMOVAL.)

12.  Connect the negative battery cable.

13.  Perform the mechanical system test. (See MECHANICAL SYSTEM TEST.)