RECEIVER/DRIER REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)]

id0711008014b1

1.  Disconnect the negative battery cable.

2.  Collect the refrigerant. (See REFRIGERANT CHARGING.)

3.  Remove the mudguard (RH). (See MUDGUARD REMOVAL/INSTALLATION.)

Caution

•  If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

4.  Remove in the order indicated in the table. Do not allow compressor oil to spill.

am2zzw00003849

1	Bolt A (See Bolt Removal Note.) (See Bolt Installation Note.)
2	Bolt B
3	Receiver/drier

5.  Install in the reverse order of removal.

6.  Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)

Bolt Removal Note

1.  Disconnect the block joint type pipes by grasping female side of the block with hand and holding firmly, then loosen the connection bolt.

am2zzw00003850

Bolt Installation Note

1.  Tighten the bolt of joint by hand.

2.  Connect the block joint type pipe by grasping the female side of the block with hand holding firmly, then tighten the connection bolt.

am2zzw00003850

3.   Tighten the joint to the specified torque.