DTC INSPECTION [BCM]

id0902f5345400

1.  Connect the M-MDS to the DLC-2.

am2zzw00002512

2.  Verify the following vehicle conditions:

•  Turn the ignition switch to the ON position.

•  All the switches are turned off (except the ignition switch).

•  All the doors, bonnet, and liftgate are closed.

•  All the doors, and liftgate are unlocked.

•  All the seat belts are unbuckled.

•  Parking brake lever is pulled.

3.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Self Test”.

2.  Select “Modules”.

3.  Select “BCM/GEM”.

•  When using the PDS (Pocket PC)

1.  Select “Module Tests”.

2.  Select “BCM/GEM”.

3.  Select “Self Test”.

4.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See DTC TABLE [BCM].)

5.  After completion of repairs, clear all DTCs stored in the BCM. (See CLEARING DTC [BCM].)