INTERIOR LIGHT REMOVAL/INSTALLATION

id091800466100

Vehicles With Intruder Sensor

1.  Disconnect the negative battery cable.

2.  Remove the intruder sensor. (See INTRUDER SENSOR REMOVAL/INSTALLATION.)

3.  Remove the lens. (See INTERIOR LIGHT BULB REMOVAL/INSTALLATION.)

4.  Remove the screw.

am2zzw00002243

5.  Remove the interior light.

6.  Disconnect the interior light connector.

7.  Install in the reverse order of removal.

Vehicles Without Intruder Sensor

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(2)  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)

(3)  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

(4)  Rain sensor cover (vehicles with rain sensor) (See RAIN SENSOR REMOVAL/INSTALLATION.)

3.  Set the headliner out of the way.

4.  Release the tabs in the direction of the arrow (1) shown in the figure and remove the interior light in the direction of the arrow (2).

am2zzw00002130

5.  Disconnect the interior light connector.

6.  Install in the reverse order of removal.