BODY CONTROL MODULE (BCM) CONFIGURATION

id094000800900

Note

•  Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the BCM CONFIGURATION.

1.  Connect the M-MDS to the DLC‐2.

am2zzw00002512

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Module Programming”.

3.  Then, select items from the screen menu in the following order.

1.  Select “Programmable Module Installation”.

2.  Select “BCM/GEM”.

4.  Perform the configuration according to the directions on the screen.

5.  Retrieve DTCs by the M-MDS, then verify that there is no DTC present.

•  If a DTC (s) is detected, perform the applicable DTC inspection. (See DTC TABLE [BCM].)