DTC P057F:00 [MZR 1.3, MZR 1.5]
id0102f8401000
|
DTC P057F:00 |
Battery voltage determination |
|---|---|
|
DETECTION CONDITION
|
• Estimated remaining battery level is specification or less.
Diagnostic support note
• This is a continuous monitor (other).
• The MIL does not illuminate.
• FREEZE FRAME DATA (Mode 2)/Snapshot data is not available.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Battery malfunction
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT BATTERY
• Turn the ignition switch off.
• Inspect the battery.
• Is there any malfunction?
|
Yes
|
Recharge or replace the battery, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the KOEO or KOER self test.
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZR 1.3, MZR 1.5].)
|
|
No
|
DTC troubleshooting completed.
|
||