CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [MZR 1.3, MZR 1.5]

id0140e6800600

Caution

•  When replacing the CKP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.3, MZR 1.5].)

2.  Remove the following parts for easier access:

(1)  Splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION.)

(2)  Drive belt (See DRIVE BELT REMOVAL/INSTALLATION [MZR 1.3, MZR 1.5].)

3.  Disconnect the CKP sensor connector.

4.  Remove the CKP sensor.

am2zzw00006060

5.  Install in the reverse order of removal.