DTC C0001:01/C0002:01/C0003:01/C0004:01/C0010:01/C0011:01/C0014:01/C0015:01/C0018:01/C0019:01/C001C:01/C001D:01 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2878200
|
DTC
|
C0001:01
C0002:01
C0003:01
C0004:01
C0010:01
C0011:01
C0014:01
C0015:01
C0018:01
C0019:01
C001C:01
C001D:01
|
Traction control solenoid valve system
Traction control solenoid valve system
Stability control solenoid valve system
Stability control solenoid valve system
LF inlet solenoid valve system
LF outlet solenoid valve system
RF inlet solenoid valve system
RF outlet solenoid valve system
LR inlet solenoid valve system
LR outlet solenoid valve system
RR inlet solenoid valve system
RR outlet solenoid valve system
|
|
|
DETECTION CONDITION
|
• Malfunction detected in the DSC HU/CM solenoid valve or internal circuit by the DSC HU/CM on-board diagnostic function
|
||
|
POSSIBLE CAUSE
|
• Open or short circuit in the DSC HU/CM internal solenoid valves
• Solenoid valve malfunction
• Poor connection at connectors (female terminal)
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY SOLENOID VALVE OPERATION
• Turn the ignition switch to the LOCK position.
• Connect the M-MDS to the DLC-2.
• Turn the ignition switch to the ON position (engine off).
• Access the active command mode for the solenoid valve using the M-MDS.
• Does the solenoid valve operate?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the DSC HU/CM, then go to the next step.
|
||
|
2
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Clear the DTC from the memory.
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Gradually slow down and stop vehicle.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY AFTER REPAIR PROCEDURE
• Are any other DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||