DTC U2100:00 [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2878800

DTC
U2100:00
Configuration data not recorded
DETECTION CONDITION
•  DSC CM detects configuration data not record or data error
POSSIBLE CAUSE
•  DSC CM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
RECORD THE CONFIGURATION DATA
•  Turn the ignition switch to the off.
•  Turn the ignition switch to the ON position, and maintain this condition for approx. 30 s.
Go to the next step.
2
VERIFY THAT THE SAME DTC IS NOT PRESENT
•  Clear the DTCs from the memory.
•  Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC CM, then go to the next step.
(See DSC HU/CM REMOVAL/INSTALLATION [L.H.D.].)
(See DSC HU/CM REMOVAL/INSTALLATION [R.H.D.].)
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCS ARE PRESENT
•  Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
No
DTC troubleshooting completed.