BASIC INSPECTION [FN4A-EL]


id050301800300

STEP

INSPECTION

ACTION

1
Measure the battery voltage.
Is the battery voltage 10.0—14.0?
Yes
Go to next step.
No
Recharge or replace the battery.
2
Inspect the PCM related harnesses, connectors and fuses.
Are they normal?
Yes
Go to next step.
No
Repair or replace any defective parts according to the inspection results.
3
Turn IG SW to ON.
When selector lever is moved, dose the selector illumination indicate synchronized position to lever location? Also, when other ranges are selected from N or P during idling, does vehicle moves within 1—2 s?
Yes
Go to next step.
No
Inspect selector lever and TR switch. Repair or replace defected areas.
If selector lever and TR switch are okay, go to next step.
4
Perform the road test.
Is the ATX operating normally?
Yes
Go to next step.
No
Repair or replace any defective parts according to the inspection results.
5
Inspect ATF color and condition.
Are ATF color and odor normal?
Yes
Go to next step.
No
Repair or replace any defective parts according to inspection result.
Flush ATX and cooler line as necessary.
6
Perform line pressure test.
Is line pressure okay?
Yes
Go to next step.
No
Repair or replace any defective parts according to inspection result.
7
Perform stall test.
Is stall speed okay?
Yes
Go to next step.
No
Repair or replace any defective parts according to inspection result.
8
Perform time lag test.
Is stall speed okay?
Yes
Go to next step.
No
Repair or replace any defective parts according to inspection result.
9
Inspect the value at the following PIDs using the M-MDS.
•  TFT
•  TFT V
•  VPWR
•  TR
•  TR SENS
•  ECT
•  TCS
•  RPM
•  APP
•  TSS
•  VSS
Are PID values okay?
Yes
Perform symptom troubleshooting and follow procedures.
No
Repair or replace any defective parts according to inspection result.