OIL SEAL REPLACEMENT [FN4A-EL]

OIL SEAL REPLACEMENT [FN4A-EL]

id051701804400

1. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FN4A-EL].)

Caution

• The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal.

2. Remove the drive shaft and/or joint shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION [MZR1.3, MZR 1.5].)(See JOINT SHAFT REMOVAL/INSTALLATION [MZR1.3, MZR 1.5].)

3. Remove the oil seal using the screwdriver.

4. Using the SST and a hammer, tap a new oil seal in evenly until the SST contacts the transaxle case.

am2zzw00000818

5. Install the drive shaft and/or joint shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION [MZR1.3, MZR 1.5].)(See JOINT SHAFT REMOVAL/INSTALLATION [MZR1.3, MZR 1.5].)

6. Add ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FN4A-EL].)

7. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [FN4A-EL].)