SOLENOID VALVE REMOVAL/INSTALLATION [FN4A-EL]

id051701804600

Warning
•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.

1.  Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

2.  Disconnect the negative battery cable.

3.  Drain the ATF into a separate suitable container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FN4A-EL].)

4.  Remove the oil pan.

5.  Remove the control valve body. (See CONTROL VALVE BODY REMOVAL [FN4A-EL].)

6.  Remove the solenoid valve(s).

am2zzw00000819

7.  Apply ATF to a new O-ring and install it on the solenoid valve.

8.  Install the solenoid valve in the control valve body.

am2zzw00000820

Tightening torque
8—10 N·m
{82—101 kgf·cm, 71—88 in·lbf}

9.  Install the control valve body. (See CONTROL VALVE BODY INSTALLATION [FN4A-EL].)

10.  Install the oil pan.

11.  Add ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FN4A-EL].)

12.  Connect the negative battery cable.

13.  Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [FN4A-EL].)