DTC U0300:00, U2100:00 [THEFT-DETERRENT SYSTEM]

id0902g7100700

DESCRIPTION
Configuration error
DETECTION CONDITION
•  Theft-deterrent control module detects the configuration error.
POSSIBLE CAUSE
•  Theft-deterrent control module configuration error
•  Configuration was not done correctly for some reason.
•  Theft-deterrent control module malfunction

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM THEFT-DETERRENT CONTROL MODULE CONFIGURATION
•  Perform the theft-deterrent control module configuration using the M-MDS.
•  Clear the DTC using the M-MDS.
•  Perform the theft-deterrent control module DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Perform the theft-deterrent control module configuration again, then go to the next step.
(See THEFT-DETERRENT CONTROL MODULE CONFIGURATION.)
No
Go to Step 3.
2
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC using the M-MDS.
•  Perform the theft-deterrent control module DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the theft-deterrent control module, then go to the next step.
(See THEFT-DETERRENT CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [THEFT-DETERRENT SYSTEM].)
No
DTC troubleshooting completed.