NO.1 CD PLAYER/CHANGER DOES NOT LOAD THE CD OR EJECTS THE CD IMMEDIATELY [CD]

id090362826100

1

CD player/changer does not load the CD or ejects the CD immediately

Possible DTC

05:Er01, 05:Er10, 10:Er01, 10:Er10, 22:Er01, 22:Er10

Possible cause

•  CD is inserted upside down

•  Audio unit malfunction

•  Defective CD (e.g., cracked, badly bent, rough edges, scratch, dirty CD, condensation)

•  Non-conventional discs (e.g., 8 cm (3 in) CD^*1, 8 cm (3 in) disc adapter^*2, heart-shaped disc, octagonal disc)

•  Poor connection of audio unit connector or terminal (e.g., damaged, bent, pulled-out pin, corrosion)

•  Deformed disc is used (e.g., out of specification (thickness), bent disc)

1	CD player/changer does not load the CD or ejects the CD immediately
Possible cause	• CD is inserted upside down • Audio unit malfunction • Defective CD (e.g., cracked, badly bent, rough edges, scratch, dirty CD, condensation) • Non-conventional discs (e.g., 8 cm (3 in) CD^1, 8 cm (3 in) disc adapter^2, heart-shaped disc, octagonal disc) • Poor connection of audio unit connector or terminal (e.g., damaged, bent, pulled-out pin, corrosion) • Deformed disc is used (e.g., out of specification (thickness), bent disc)

*1 :with CD changer

*2 :with CD player

Diagnostic procedure

STEP	INSPECTION		ACTION
1	• Is CD inserted properly, label-side up?	Yes	Go to the next step.
1	• Is CD inserted properly, label-side up?	No	Explain to the customer that CD should be inserted into the slot, label-side up.
2	• Replace with a CD known to be good. • Does the CD player/changer load the CD?	Yes	Go to the next step.
2		No	Replace the audio unit. (See CENTER PANEL UNIT REMOVAL/INSTALLATION.) (See CENTER PANEL UNIT DISASSEMBLY/ASSEMBLY.)
3	Visually inspect the CD. ― Is there any dirt, scratch or deformation on the CD? ― Is the CD a non-conventional disc?	Yes	Explain to the customer that the defective CD or non-conventional disc cannot be used.
3		No	Go to the next step.
4	• Turn the ignition switch to the LOCK position. • Inspect the connection of the audio unit connector (24-pin). • Inspect both audio unit connector and wiring harness-side connector for a poor connection. (such as damaged/bent/pulled-out pins, corrosion) • Are all the pins and connector normal?	Yes	Replace the audio unit. (See CENTER PANEL UNIT REMOVAL/INSTALLATION.) (See CENTER PANEL UNIT DISASSEMBLY/ASSEMBLY.)
4		No	If the audio unit connector/pin is malfunctioning: • Replace the audio unit. (See CENTER PANEL UNIT REMOVAL/INSTALLATION.) (See CENTER PANEL UNIT DISASSEMBLY/ASSEMBLY.) If the wiring harness-side connector/pin is malfunctioning: • Repair or replace the pins and/or the connector.