BODY CONTROL MODULE (BCM) BRACKET REMOVAL/INSTALLATION


id094000801500


Removal

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

1.  Dashboard under cover. (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)
2.  Front scuff plate. (passenger’s side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
3.  Front side trim. (passenger’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

3.  Insert a fastener remover in the direction of the arrow (1) shown in the figure and release the tabs.

Caution
•  Because the tabs will break if they are bent excessively, bend the tabs only so far as to allow them to release from the BCM.
am2uuw00000866

4.  Pull the BCM in the direction of the arrow (2) as shown in the figure and remove the BCM bracket.

am2zzw00004127


Installation

1.  Bend the tabs in the direction of the arrow (1) so that clearance (a) indicated in the figure is within the specification.

am2zzw00006271

Clearance
a: 0.8―1.2 mm {0.032―0.047 in}

2.  Press the BCM in the direction of the arrow (2) as shown in the figure and install it.

am2zzw00004129

3.  Install the following parts:

2.  Front side trim. (passenger’s side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
3.  Front scuff plate. (passenger’s side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
4.  Dashboard under cover. (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

4.  Connect the negative battery cable.