CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [ZY, Z6]

id0140a0800600

Caution

•  When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing.

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [ZY, Z6].)

2.  Disconnect the negative battery cable.

3.  Remove the aerodynamic under cover No.2 and splash shield as a single unit. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.) (See SPLASH SHIELD REMOVAL/INSTALLATION.)

4.  Remove the nut shown in the figure and set the power steering pipe component out of the way.

am3zzw00008678

5.  Disconnect the CKP sensor connector.

6.  Remove the CKP sensor.

am3zzw00004928

7.  Install in the reverse order of removal.