CAMSHAFT POSITION (CMP) SENSOR INSPECTION [L3 Turbo]

id0140b6801400

Visual Inspection

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 Turbo].)

2.  Disconnect the negative battery cable.

3.  Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [L3 Turbo].)

4.  Verify that there are no metal shavings on the sensor.

•  Remove any metal shavings that are adhering.

Voltage Inspection

1.  Idle the engine.

2.  Measure the CMP sensor output wave pattern using an oscilloscope. (See PCM INSPECTION [L3 Turbo])

•  If not within the specification, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [L3 Turbo].)