DTC C0051:28 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2884500
|
DTC
|
C0051:28
|
Steering angle sensor
|
|
|
DETECTION CONDITION
|
• The steering angle sensor detects signal modulation or steering angle that exceeds specification.
|
||
|
POSSIBLE CAUSE
|
• Improper installation or positioning of the steering angle sensor
• Steering angle sensor malfunction
• Connector or terminal malfunction
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
PERFORM BCM DTC INSPECTION
• Perform the BCM DTC inspection.
(See DTC INSPECTION [BCM].)
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [BCM].)
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Clear the DTCs from the memory.
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||