DTC U2100:00/U2101:00 [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2887800

DTC
U2100:00, U2101:00
Configuration data not recorded
DETECTION CONDITION
•  DSC CM detects configuration data not record or data error
POSSIBLE CAUSE
•  Module configuration procedure is not done properly
•  Correct data cannot be received from instrument cluster

Diagnostic procedure

STEP

INSPECTION

ACTION
1
RECORD THE CAR CONFIGURATION DATA
•  Switch the ignition to off.
•  Switch the ignition to ON, and maintain this condition for approx. 30 s.
Go to the next step.
2
VERIFY THAT THE SAME DTC IS NOT PRESENT
•  Clear the DTCs from the memory.
•  Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
If the malfunction recurs, go to the next step.
No
Go to Step 5.
3
INSPECT FOR INSTRUMENT CLUSTER MALFUNCTION
•  Switch the ignition to off.
•  Using the M-MDS, perform the DTC inspection for the instrument cluster.
•  Are any DTCs detected?
Yes
Go to applicable DTC inspection.
(See DTC TABLE [INSTRUMENT CLUSTER].)
After repairing the instrument cluster, perform the “INSTRUMENT CLUSTER CONFIGURATION”, then go to the next step.
(See INSTRUMENT CLUSTER CONFIGURATION.)
No
Go to the next step.
4
VERIFY THAT THE SAME DTC IS NOT PRESENT
•  Clear the DTCs from the memory.
•  Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
No
Go to the next step.
5
VERIFY THAT NO OTHER DTCS ARE PRESENT
•  Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
No
DTC troubleshooting completed.