OIL SEAL (DIFFERENTIAL) REPLACEMENT [G66M-R]

id0515k1800200

1.  On level ground, jack up the vehicle and support it evenly on safety stands.

2.  Remove the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

3.  Drain the oil from the transaxle. (See TRANSAXLE OIL REPLACEMENT [G66M-R].)

4.  Remove the front splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION.)

5.  Separate the drive shaft and joint shaft from the transaxle. (See DRIVE SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/INSTALLATION [LF, MZR 2.0 DISI i-stop].) (See JOINT SHAFT REMOVAL/INSTALLATION [ZY, Z6, L3 Turbo, L5].)

6.  Remove the oil seals using a screwdriver.

am6xuw00001512

7.  Using the SST and a hammer, tap each new oil seal in evenly until the SST contacts the transaxle case.

am6xuw00001513

8.  Coat the lip of each oil seal with transaxle oil.

9.  Insert the drive shaft and joint shaft to the transaxle. (See DRIVE SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/INSTALLATION [LF, MZR 2.0 DISI i-stop].) (See JOINT SHAFT REMOVAL/INSTALLATION [ZY, Z6, L3 Turbo, L5].)

10.  Install the front splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION.)

11.  Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT [G66M-R].)

12.  Install the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)