TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [FS5A-EL]

id051721291900

Caution

•  Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1.  Select the selector lever to N position.

2.  Perform the following procedures.

(1)  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5].) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)

(2)  Disconnect the negative battery cable.

(3)  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF, L5].) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)

(4)  Disconnect the TR switch connector.

am8rrw00002332

3.  Loosen the TR switch.

(1)  Remove the clip from the selector cable.

(2)  Disconnect the selector cable from manual shaft lever.

am3uuw00002407

(3)  Loosen the TR switch installation bolts.

ampjjw00005635

4.  Adjust the TR switch.

(1)  Verify that the manual shaft is aligned with N position.

am3uuw00002408

(2)  Adjust the TR switch between terminals B and C until the resistance becomes specification.

am3uuw00002409

TR switch specification

713—788 ohms

(3)  Tighten the TR switch installation bolts.

Tightening torque

8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}