POWER STEERING FLUID LINE COMPONENT REMOVAL/INSTALLATION [R.H.D.]

id0614008070d4

Note

•  The following procedure is for replacement of the parts shown in the figure. Regarding replacement of the suction hose and return hose, refer to the electric power steering oil pump component removal/installation. (See ELECTRIC POWER STEERING OIL PUMP COMPONENT REMOVAL/INSTALLATION.)

am3zzw00004884

Power Steering Pipe Component Removal/Installation

Note

•  The pressure pipe and return pipe are integrated with the power steering pipe component. Therefore, if any one of the pipes has a malfunction, replace the power steering pipe component.

1.  Remove the front mudguard (RH). (See FRONT MUDGUARD REMOVAL/INSTALLATION.)

2.  Remove the splash shield and aerodynamic under cover NO.2 as a single unit. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

3.  Remove the connecting bolt (pump side) from the electric power steering oil pump and disconnect the return hose from the power steering pipe component (return pipe).

am3uuw00002630

Note

•  Drain the power steering fluid.

4.  Remove the nut shown in the figure.

am3zzw00008270

5.  Remove in the order indicated in the table.

6.  Install in the reverse order of removal.

am3zzw00005179

1	Connecting bolt (steering gear side)
2	Hose clips
3	Power steering pipe component