PUSH BUTTON START REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]

id0921008022z5

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

1.  Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

2.  Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

3.  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

4.  Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

5.  Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

6.  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

7.  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

8.  Console (See CONSOLE REMOVAL/INSTALLATION.)

3.  Set the bonnet release lever out of the way. (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

4.  Remove the lower panel. (driver-side) (See LOWER PANEL REMOVAL/INSTALLATION.)

5.  Release the tabs and remove the push button start from the lower panel.

am3uuw00002509

6.  Install in the reverse order of removal.