DTC P0607[LF ATX (FN4A-EL), L3 ATX]

id0102b6809500

DTC P0607

PCM performance problem

DETECTION CONDITION

•  The PCM internal malfunction

Diagnostic support note

•  This is a continuous monitor (Other).

•  The MIL does not illuminate.

•  FREEZE FRAME DATA is not available.

•  DTC is stored in PCM memory.

POSSIBLE CAUSE

•  PCM internal malfunction

DTC P0607	PCM performance problem
DETECTION CONDITION	• The PCM internal malfunction Diagnostic support note • This is a continuous monitor (Other). • The MIL does not illuminate. • FREEZE FRAME DATA is not available. • DTC is stored in PCM memory.
POSSIBLE CAUSE	• PCM internal malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA on repair order, then go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING OF P0607 COMPLETED • Make sure to reconnect all disconnected connectors. • Clear DTC from PCM memory using M-MDS. • Start the engine, or perform the KOEO or KOER self‐test • Is same DTC present?	Yes	Replace PCM, go to the next step. (See PCM REMOVAL/INSTALLATION[LF, L3].)
3		No	Go to the next step.
4	VERIFY AFTER REPAIR PROCEDURE • Perform “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE[LF ATX (FN4A-EL), L3 ATX].) • Is any DTC present?	Yes	Go to applicable DTC inspection. (See DTC TABLE[LF ATX (FN4A-EL), L3 ATX].)
4		No	Troubleshooting completed.