DTC P0607[L3 Turbo]
id0102b7809500
|
DTC P0607 |
PCM performance problem |
|---|---|
|
DETECTION CONDITION
|
• PCM internal malfunction.
Diagnostic support note
• This is a continuous monitor (Other).
• MIL does not illuminate.
• FREEZE FRAME DATA is not available.
• DTCs are stored in PCM memory.
|
|
POSSIBLE CAUSE
|
• PCM internal malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform the repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY TROUBLESHOOTING OF P0607 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Start engine.
• Is same DTC present?
|
Yes
|
Replace PCM, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “After Repair Procedure”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE[L3 Turbo].)
|
|
No
|
Troubleshooting completed.
|
||